|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 1st, 2021, 07:34 AM
posted to can.rec.fishing
|
|||
|
|||
XanaNews Statistic for can.rec.fishing. 6/1/2021 12:34:54 AM
XanaNews Statistic for can.rec.fishing. 6/1/2021 12:34:54 AM
From article 2804 (5/1/2021 12:51:35 AM) to article 2809 (5/11/2021 1:32:40 AM) Number of threads ................... 6 Number of articles .................. 6 Average articles per thread ......... 1.00 Number of unanswered posts .......... 6 Number of posts from XanaNews users .. 1 Top Threads Ranking Articles Subject ------- -------- ---------------------------------- Top Posters Ranking Articles Name Most Used Newsreader ------- -------- -------------------------- -------------------- 1 5 Rod Wesler G2 2 1 The Doctor XanaNews Top Newsreaders Ranking Articles Newsreader Users ------- -------- -------------------------------------------- ----- 1 5 G2 1 2 1 XanaNews 1 -- The lie of USenet is dying is rebuff by these statistics Usenet lives or the internet dies 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| XanaNews Statistic for can.rec.fishing. 5/1/2021 12:51:30 AM | The Doctor | Fishing in Canada | 0 | May 1st, 2021 07:51 AM |
| XanaNews Statistic for can.rec.fishing. 4/1/2021 5:17:33 AM | The Doctor | Fishing in Canada | 0 | April 1st, 2021 12:17 PM |
| XanaNews Statistic for can.rec.fishing. 3/1/2021 12:20:53 AM | The Doctor | Fishing in Canada | 0 | March 1st, 2021 07:20 AM |
| XanaNews Statistic for can.rec.fishing. 2/1/2021 12:35:06 AM | The Doctor | Fishing in Canada | 0 | February 1st, 2021 07:35 AM |
| XanaNews Statistic for can.rec.fishing. 12/1/2020 7:37:47 AM | The Doctor | Fishing in Canada | 0 | December 1st, 2020 02:37 PM |
Linear Mode
